Inspect a Forklift
There are over 10,000 workplace injuries related to forklifts happen each year, according to HRSDC and OSHA reports. A lot of these accidents are caused by driver error. Lack of proper equipment maintenance and check results in many others. Operation and maintenance of a forklift is not just the reason for personal injuries, but also of damage to property. Forklifts can damage building structures, overhead pipes and sprinklers, and other machinery when utilized incorrectly. The following day by day check ups should be carried out in order to lessen the possibility of forklift mishaps.
Prior to checking different fluid levels turn the engine off. Inspect these fluids: fuel, engine oil, hydraulic oil, brake fluid and coolant. The tires also have to be inspected for signs of wear and tear. Check the tire air pressure. Check the condition of the forks. The load backrest should be attached firmly. Do a visual inspection of the top-clip retaining pin and heel. After that carry out an inspection of the mast chains, hydraulic hoses, cables and stops. Ensure that the finger and overhead guards are securely attached.
The LP powered forklift has propane tanks which need to be inspected for rust, corrosion or damage. The battery's electrolyte levels and charge have to be tested every so often. Seat belts need to be inspected for wear and tear. Check to make certain the owner's instruction manual is stored on-board the forklift inside a storage compartment. Test the seat belt to make certain the latches are secure. Test the hood latch to make certain that it is working as it should.
To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate promptly. Test the accelerator and the steering controls. The parking break and the service break should be working properly.
To ensure proper functioning in both reverse and forward, the drive control and tilt control should be checked. The functioning of the hoist, the lowering control and attachment control requires periodic checking. Check the lights and horn. Then check the wipers, heater and defroster to make certain they are working smoothly. Check each gauge to find out that it is reading within functional limits.