Change a Propane Tank
Forklifts fueled by propane are common in warehouse environments. These forklifts have a propane mount located behind the operator. These tanks need to be replaced from time to time because they have limited lifespans. Drivers of forklifts should utilize care when handling propane tanks. Compressed gases are dangerous, specially since the gas is flammable. Utilize caution when removing and replacing propane tank to prevent being injured.
1 If there is a need to change the propane tank, the first step is to stop the forklift, then turn off the tank valve. The forklift should be left on until the engine dies. This process burns the gas off inside the transfer hose that connects the tank and the engine. Prior to taking the second steps, wear the correct safety equipment, like for example insulated gloves made of either neoprene or leather. It is essential for you to protect your skin from contact with the compressed gas, that is extremely cold.
2 The hose of the tank needs to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, tighten the nut to reconnect the holding straps and to reattach the hose at the valve of the tank.
3 You could check for leaks by applying soapy water to the valve and slightly opening it. Leaking gas will cause bubbles to foam around the value. If this occurs, check the connection hose at the nut and the valve area. The connecting nut must be re-tightened if you detect any leaks around the valve area, and afterward perform the leak inspection procedure again. Persistent leaks mean that the connecting hose and nut would have to be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. Afterward you could start the forklift and resume operating.